/dev/sda === START OF INFORMATION SECTION === Device Model: SAMSUNG HD080HJ/P Serial Number: -- Firmware Version: ZH100-41 User Capacity: 80 026 361 856 bytes [80,0 GB] Sector Size: 512 bytes logical/physical Device is: Not in smartctl database [for details use: -P showall] ATA Version is: ATA/ATAPI-7 T13/1532D revision 4a Local Time is: Wed Dec 30 17:12:00 2015 MSK SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM feature is: Unavailable Rd look-ahead is: Enabled Write cache is: Enabled ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 1848) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 1) minutes. Extended self-test routine recommended polling time: ( 30) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 100 100 025 - 3840 4 Start_Stop_Count -O--CK 099 099 000 - 1919 5 Reallocated_Sector_Ct PO--CK 253 253 010 - 0 7 Seek_Error_Rate POSR-- 253 253 051 - 0 8 Seek_Time_Performance P-S--K 253 253 015 - 0 9 Power_On_Hours -O--CK 100 100 000 - 4818 10 Spin_Retry_Count PO--CK 253 253 051 - 0 11 Calibration_Retry_Count -O--C- 253 253 000 - 0 12 Power_Cycle_Count -O--CK 099 099 000 - 1189 187 Reported_Uncorrect -O--CK 253 253 000 - 0 190 Airflow_Temperature_Cel -O---K 088 085 000 - 50 194 Temperature_Celsius -O---K 088 085 000 - 50 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 787210 196 Reallocated_Event_Count -O--CK 253 253 000 - 0 197 Current_Pending_Sector -O--C- 253 253 000 - 0 198 Offline_Uncorrectable ----CK 253 253 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O-R-- 100 100 000 - 0 202 Data_Address_Mark_Errs -O--CK 253 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters 0x80-0x9f GPL,SL R/W 16 Host vendor specific log SMART Extended Comprehensive Error Log Version: 1 (2 sectors) Invalid Error Log index = 0x0000, trying reserved byte (0x01) instead Device Error Count: 1 CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 1 [0] occurred at disk power-on lifetime: 3280 hours (136 days + 16 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER -- ST COUNT LBA_48 LH LM LL DV DC -- -- -- == -- == == == -- -- -- -- -- 04 -- 51 00 00 00 00 f2 37 00 00 e4 00 Error: ABRT at LBA = 0xf6370000 = 4130799616 Commands leading to the command that caused the error were: CR FEATR COUNT LBA_48 LH LM LL DV DC Powered_Up_Time Command/Feature_Name -- == -- == -- == == == -- -- -- -- -- --------------- -------------------- ca 00 00 00 00 00 00 00 f2 37 00 e4 00 00:12:06.500 WRITE DMA ca 00 00 00 00 00 00 00 f2 36 00 e4 00 00:12:06.500 WRITE DMA ca 00 00 00 00 00 00 00 f2 35 00 e4 00 00:12:06.500 WRITE DMA ca 00 00 00 00 00 00 00 f2 34 00 e4 00 00:12:06.500 WRITE DMA ca 00 00 00 00 00 00 00 f2 33 00 e4 00 00:12:06.500 WRITE DMA SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 No self-tests have been logged. [To run self-tests, use: smartctl -t] SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) SCT Support Level: 1 Device State: Active (0) Current Temperature: 50 Celsius Power Cycle Max Temperature: 51 Celsius Lifetime Max Temperature: 51 Celsius SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 10/55 Celsius Min/Max Temperature Limit: 5/60 Celsius Temperature History Size (Index): 128 (126) Index Estimated Time Temperature Celsius 127 2015-12-30 15:05 42 *********************** 0 2015-12-30 15:06 ? - 1 2015-12-30 15:07 36 ***************** 2 2015-12-30 15:08 37 ****************** 3 2015-12-30 15:09 38 ******************* 4 2015-12-30 15:10 38 ******************* 5 2015-12-30 15:11 39 ******************** 6 2015-12-30 15:12 40 ********************* 7 2015-12-30 15:13 40 ********************* 8 2015-12-30 15:14 40 ********************* 9 2015-12-30 15:15 41 ********************** 10 2015-12-30 15:16 41 ********************** 11 2015-12-30 15:17 42 *********************** 12 2015-12-30 15:18 42 *********************** 13 2015-12-30 15:19 43 ************************ 14 2015-12-30 15:20 43 ************************ 15 2015-12-30 15:21 43 ************************ 16 2015-12-30 15:22 44 ************************* 17 2015-12-30 15:23 44 ************************* 18 2015-12-30 15:24 44 ************************* 19 2015-12-30 15:25 45 ************************** 20 2015-12-30 15:26 47 **************************** ... ..( 2 skipped). .. **************************** 23 2015-12-30 15:29 47 **************************** 24 2015-12-30 15:30 48 ***************************** ... ..( 4 skipped). .. ***************************** 29 2015-12-30 15:35 48 ***************************** 30 2015-12-30 15:36 49 ****************************** 31 2015-12-30 15:37 ? - 32 2015-12-30 15:38 49 ****************************** 33 2015-12-30 15:39 49 ****************************** 34 2015-12-30 15:40 50 ******************************* ... ..( 12 skipped). .. ******************************* 47 2015-12-30 15:53 50 ******************************* 48 2015-12-30 15:54 51 ******************************** ... ..( 58 skipped). .. ******************************** 107 2015-12-30 16:53 51 ******************************** 108 2015-12-30 16:54 50 ******************************* 109 2015-12-30 16:55 51 ******************************** 110 2015-12-30 16:56 50 ******************************* 111 2015-12-30 16:57 50 ******************************* 112 2015-12-30 16:58 51 ******************************** 113 2015-12-30 16:59 50 ******************************* 114 2015-12-30 17:00 51 ******************************** 115 2015-12-30 17:01 51 ******************************** 116 2015-12-30 17:02 51 ******************************** 117 2015-12-30 17:03 50 ******************************* ... ..( 8 skipped). .. ******************************* 126 2015-12-30 17:12 50 ******************************* SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP Log 0x04) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x000a 2 11 Device-to-host register FISes sent due to a COMRESET 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 5 Transition from drive PhyRdy to drive PhyNRdy 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x8001 2 0 Vendor specific