/dev/sda smartctl 7.1 2019-12-30 r5022 [x86_64-linux-5.4.0-64-generic] (local build) Copyright (C) 2002-19, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Western Digital Scorpio Blue Serial ATA Device Model: WDC WD6400BEVT-60A0RT0 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 01.01A01 User Capacity: 640,135,028,736 bytes [640 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.6, 3.0 Gb/s Local Time is: Fri Jan 22 21:10:59 2021 CET SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: (15180) seconds. Offline data collection capabilities: (0x51) SMART execute Offline immediate. No Auto Offline data collection support. Suspend Offline collection upon new command. No Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 176) minutes. SCT capabilities: (0x703f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 0 3 Spin_Up_Time POS--K 186 154 021 - 1658 4 Start_Stop_Count -O--CK 097 097 000 - 3105 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate POSR-K 100 253 051 - 0 9 Power_On_Hours -O--CK 095 095 000 - 3993 10 Spin_Retry_Count PO--CK 100 100 051 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 2769 183 Runtime_Bad_Block -O--CK 100 100 000 - 0 187 Reported_Uncorrect -O--CK 100 100 000 - 0 188 Command_Timeout -O--CK 100 093 000 - 963 190 Airflow_Temperature_Cel -O---K 063 034 040 Past 37 (2 141 37 24 0) 191 G-Sense_Error_Rate -O--CK 001 001 000 - 1149 192 Power-Off_Retract_Count -O--CK 200 200 000 - 114 193 Load_Cycle_Count -O--CK 111 111 000 - 267872 194 Temperature_Celsius -O---K 110 081 000 - 37 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 0 200 Multi_Zone_Error_Rate P--R-- 100 253 051 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 24 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 295 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 258 (0x0102) Device State: Active (0) Current Temperature: 37 Celsius Power Cycle Min/Max Temperature: 24/37 Celsius Lifetime Min/Max Temperature: ?/64 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: -41/85 Celsius Temperature History Size (Index): 128 (7) Index Estimated Time Temperature Celsius 8 2021-01-22 19:03 40 ********************* ... ..( 7 skipped). .. ********************* 16 2021-01-22 19:11 40 ********************* 17 2021-01-22 19:12 41 ********************** 18 2021-01-22 19:13 40 ********************* ... ..( 41 skipped). .. ********************* 60 2021-01-22 19:55 40 ********************* 61 2021-01-22 19:56 41 ********************** ... ..( 25 skipped). .. ********************** 87 2021-01-22 20:22 41 ********************** 88 2021-01-22 20:23 40 ********************* 89 2021-01-22 20:24 41 ********************** 90 2021-01-22 20:25 41 ********************** 91 2021-01-22 20:26 41 ********************** 92 2021-01-22 20:27 ? - 93 2021-01-22 20:28 21 ** 94 2021-01-22 20:29 23 **** 95 2021-01-22 20:30 23 **** 96 2021-01-22 20:31 25 ****** 97 2021-01-22 20:32 26 ******* 98 2021-01-22 20:33 27 ******** 99 2021-01-22 20:34 27 ******** 100 2021-01-22 20:35 27 ******** 101 2021-01-22 20:36 28 ********* ... ..( 6 skipped). .. ********* 108 2021-01-22 20:43 28 ********* 109 2021-01-22 20:44 29 ********** 110 2021-01-22 20:45 29 ********** 111 2021-01-22 20:46 29 ********** 112 2021-01-22 20:47 30 *********** 113 2021-01-22 20:48 30 *********** 114 2021-01-22 20:49 29 ********** 115 2021-01-22 20:50 30 *********** 116 2021-01-22 20:51 ? - 117 2021-01-22 20:52 24 ***** 118 2021-01-22 20:53 25 ****** 119 2021-01-22 20:54 26 ******* 120 2021-01-22 20:55 28 ********* 121 2021-01-22 20:56 28 ********* 122 2021-01-22 20:57 29 ********** 123 2021-01-22 20:58 30 *********** 124 2021-01-22 20:59 30 *********** 125 2021-01-22 21:00 31 ************ 126 2021-01-22 21:01 32 ************* 127 2021-01-22 21:02 33 ************** 0 2021-01-22 21:03 34 *************** 1 2021-01-22 21:04 35 **************** 2 2021-01-22 21:05 35 **************** 3 2021-01-22 21:06 36 ***************** ... ..( 2 skipped). .. ***************** 6 2021-01-22 21:09 36 ***************** 7 2021-01-22 21:10 37 ****************** SCT Error Recovery Control: Read: 85 (8.5 seconds) Write: 85 (8.5 seconds) Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x000a 2 1 Device-to-host register FISes sent due to a COMRESET 0x000b 2 0 CRC errors within host-to-device FIS 0x8000 4 1087 Vendor specific