/dev/sda smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.19.0-35-generic] (local build) Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: SAMSUNG SpinPoint M5 Device Model: SAMSUNG HM121HI Serial Number: -- LU WWN Device Id: 5 0f0000 ... Firmware Version: LZ100-08 User Capacity: 120,034,123,776 bytes [120 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS, ATA/ATAPI-7 T13/1532D revision 0 SATA Version is: SATA 2.5, 1.5 Gb/s Local Time is: Thu Mar 2 19:18:33 2023 -03 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 32) The self-test routine was interrupted by the host with a hard or soft reset. Total time to complete Offline data collection: ( 48) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 48) minutes. SCT capabilities: (0x003f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 100 100 051 - 0 3 Spin_Up_Time POS--- 252 252 025 - 2062 4 Start_Stop_Count -O--CK 080 080 000 - 20883 5 Reallocated_Sector_Ct PO--CK 100 100 010 - 2 7 Seek_Error_Rate POSR-- 252 252 051 - 0 8 Seek_Time_Performance --S--K 252 252 015 - 0 9 Power_On_Hours -O--CK 081 081 000 - 9901 10 Spin_Retry_Count -O--CK 100 100 051 - 25 12 Power_Cycle_Count -O--CK 090 090 000 - 10650 191 G-Sense_Error_Rate -O--CK 099 099 000 - 15019 192 Power-Off_Retract_Count -O--CK 100 100 000 - 1081 194 Temperature_Celsius -O---K 121 067 000 - 39 (Min/Max 14/57) 195 Hardware_ECC_Recovered -O-RC- 100 100 000 - 1370 196 Reallocated_Event_Count -O--CK 252 252 000 - 0 197 Current_Pending_Sector -O--C- 252 252 000 - 0 198 Offline_Uncorrectable ----CK 252 252 000 - 0 199 UDMA_CRC_Error_Count -OS-CK 200 200 000 - 35 200 Multi_Zone_Error_Rate -O-R-- 100 100 000 - 0 201 Soft_Read_Error_Rate -O--CK 252 252 000 - 0 223 Load_Retry_Count -O--CK 100 100 000 - 221 225 Load_Cycle_Count -O--CK 093 093 000 - 73337 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 2 Comprehensive SMART error log 0x03 GPL R/O 2 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x08 SL R/O 1 Power Conditions log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80 GPL,SL R/W 16 Host vendor specific log 0x81-0x9f SL R/W 16 Host vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (2 sectors) Device Error Count: 86 (device log contains only the most recent 8 errors) CR = Command Register FEATR = Features Register COUNT = Count (was: Sector Count) Register LBA_48 = Upper bytes of LBA High/Mid/Low Registers ] ATA-8 LH = LBA High (was: Cylinder High) Register ] LBA LM = LBA Mid (was: Cylinder Low) Register ] Register LL = LBA Low (was: Sector Number) Register ] DV = Device (was: Device/Head) Register DC = Device Control Register ER = Error register ST = Status register Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. ATA_READ_LOG_EXT (addr=0x03:0x00, page=1, n=1) failed: scsi error badly formed scsi parameters SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 9247 - # 2 Extended offline Completed without error 00% 7376 - # 3 Short offline Completed without error 00% 7375 - # 4 Short offline Completed without error 00% 7172 - # 5 Short offline Completed without error 00% 7113 - # 6 Extended offline Aborted by host 150% 4803 - SMART Selective self-test log data structure revision number 0 Note: revision number not 1 implies that no selective self-test has ever been run SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Interrupted [00% left] (0-65535) 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 256 (0x0100) Device State: Active (0) Current Temperature: 39 Celsius Power Cycle Min/Max Temperature: 25/39 Celsius Lifetime Min/Max Temperature: 15/60 Celsius Under/Over Temperature Limit Count: 0/0 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 15/55 Celsius Min/Max Temperature Limit: 10/60 Celsius Temperature History Size (Index): 128 (126) Index Estimated Time Temperature Celsius 127 2023-03-02 17:11 41 ********************** ... ..( 2 skipped). .. ********************** 2 2023-03-02 17:14 41 ********************** 3 2023-03-02 17:15 42 *********************** ... ..( 12 skipped). .. *********************** 16 2023-03-02 17:28 42 *********************** 17 2023-03-02 17:29 43 ************************ ... ..( 25 skipped). .. ************************ 43 2023-03-02 17:55 43 ************************ 44 2023-03-02 17:56 44 ************************* ... ..( 8 skipped). .. ************************* 53 2023-03-02 18:05 44 ************************* 54 2023-03-02 18:06 42 *********************** ... ..( 7 skipped). .. *********************** 62 2023-03-02 18:14 42 *********************** 63 2023-03-02 18:15 43 ************************ ... ..( 3 skipped). .. ************************ 67 2023-03-02 18:19 43 ************************ 68 2023-03-02 18:20 46 *************************** ... ..( 24 skipped). .. *************************** 93 2023-03-02 18:45 46 *************************** 94 2023-03-02 18:46 44 ************************* ... ..( 3 skipped). .. ************************* 98 2023-03-02 18:50 44 ************************* 99 2023-03-02 18:51 ? - 100 2023-03-02 18:52 25 ****** 101 2023-03-02 18:53 27 ******** 102 2023-03-02 18:54 29 ********** 103 2023-03-02 18:55 30 *********** 104 2023-03-02 18:56 32 ************* 105 2023-03-02 18:57 33 ************** 106 2023-03-02 18:58 33 ************** 107 2023-03-02 18:59 33 ************** 108 2023-03-02 19:00 34 *************** 109 2023-03-02 19:01 34 *************** 110 2023-03-02 19:02 34 *************** 111 2023-03-02 19:03 36 ***************** 112 2023-03-02 19:04 37 ****************** 113 2023-03-02 19:05 37 ****************** 114 2023-03-02 19:06 37 ****************** 115 2023-03-02 19:07 38 ******************* 116 2023-03-02 19:08 38 ******************* 117 2023-03-02 19:09 38 ******************* 118 2023-03-02 19:10 39 ******************** ... ..( 7 skipped). .. ******************** 126 2023-03-02 19:18 39 ******************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x000a 2 3 Device-to-host register FISes sent due to a COMRESET 0x0008 2 0 Device-to-host non-data FIS retries 0x0009 2 0 Transition from drive PhyRdy to drive PhyNRdy 0x000b 2 0 CRC errors within host-to-device FIS 0x000d 2 0 Non-CRC errors within host-to-device FIS 0x8001 2 0 Vendor specific