/dev/sda === START OF INFORMATION SECTION === Model Family: Western Digital Scorpio Blue Serial ATA Device Model: WDC WD2500BEVT-75ZCT2 Serial Number: -- LU WWN Device Id: 5 0014ee ... Firmware Version: 11.01A11 User Capacity: 250,059,350,016 bytes [250 GB] Sector Size: 512 bytes logical/physical Rotation Rate: 5400 rpm Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.5, 3.0 Gb/s Local Time is: Sun Jul 1 13:42:44 2018 +05 SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Disabled APM level is: 254 (maximum performance) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, frozen [SEC2] Wt Cache Reorder: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x85) Offline data collection activity was aborted by an interrupting command from host. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 7800) seconds. Offline data collection capabilities: (0x7b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 93) minutes. Conveyance self-test routine recommended polling time: ( 5) minutes. SCT capabilities: (0x303f) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-K 200 200 051 - 1 3 Spin_Up_Time POS--K 187 186 021 - 1616 4 Start_Stop_Count -O--CK 095 095 000 - 5589 5 Reallocated_Sector_Ct PO--CK 200 200 140 - 0 7 Seek_Error_Rate -OSR-K 100 253 000 - 0 9 Power_On_Hours -O--CK 092 092 000 - 5970 10 Spin_Retry_Count -O--CK 100 100 000 - 0 11 Calibration_Retry_Count -O--CK 100 100 000 - 0 12 Power_Cycle_Count -O--CK 098 098 000 - 2845 192 Power-Off_Retract_Count -O--CK 200 200 000 - 216 193 Load_Cycle_Count -O--CK 160 160 000 - 122289 194 Temperature_Celsius -O---K 099 082 000 - 48 196 Reallocated_Event_Count -O--CK 200 200 000 - 0 197 Current_Pending_Sector -O--CK 200 200 000 - 0 198 Offline_Uncorrectable ----CK 100 253 000 - 0 199 UDMA_CRC_Error_Count -O--CK 200 200 000 - 3 200 Multi_Zone_Error_Rate ---R-- 200 200 000 - 0 240 Head_Flying_Hours -O--CK 093 093 000 - 5518 241 Total_LBAs_Written -O--CK 166 001 000 - 34372131331048 242 Total_LBAs_Read -O--CK 200 200 000 - 14411175609 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory Version 1 SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 GPL,SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 GPL R/O 6 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 GPL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 GPL R/O 1 NCQ Command Error log 0x11 GPL R/O 1 SATA Phy Event Counters log 0x80-0x9f GPL,SL R/W 16 Host vendor specific log 0xa0-0xa7 GPL,SL VS 16 Device vendor specific log 0xa8-0xb7 GPL,SL VS 1 Device vendor specific log 0xc0 GPL,SL VS 1 Device vendor specific log 0xc1 GPL VS 24 Device vendor specific log 0xe0 GPL,SL R/W 1 SCT Command/Status 0xe1 GPL,SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log Version: 1 (6 sectors) No Errors Logged SMART Extended Self-test Log Version: 1 (1 sectors) Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Extended offline Completed without error 00% 5967 - # 2 Offline Completed without error 00% 5959 - # 3 Offline Completed without error 00% 5954 - # 4 Offline Completed without error 00% 5945 - # 5 Extended offline Completed without error 00% 5941 - # 6 Offline Completed without error 00% 5939 - # 7 Extended offline Completed without error 00% 5880 - # 8 Offline Completed without error 00% 5857 - # 9 Extended offline Completed without error 00% 5823 - #10 Extended offline Completed without error 00% 5812 - #11 Extended offline Completed without error 00% 5806 - #12 Offline Completed without error 00% 5800 - #13 Offline Completed without error 00% 5786 - #14 Extended offline Completed without error 00% 5766 - #15 Offline Completed without error 00% 5749 - #16 Extended offline Completed without error 00% 5722 - #17 Extended offline Completed without error 00% 5708 - #18 Offline Completed without error 00% 5687 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 258 (0x0102) SCT Support Level: 1 Device State: Active (0) Current Temperature: 47 Celsius Power Cycle Min/Max Temperature: 28/48 Celsius Lifetime Min/Max Temperature: 47/65 Celsius Under/Over Temperature Limit Count: 0/0 Vendor specific: 01 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 SCT Temperature History Version: 2 Temperature Sampling Period: 1 minute Temperature Logging Interval: 1 minute Min/Max recommended Temperature: 0/60 Celsius Min/Max Temperature Limit: 1/85 Celsius Temperature History Size (Index): 128 (24) Index Estimated Time Temperature Celsius 25 2018-07-01 11:35 39 ******************** 26 2018-07-01 11:36 40 ********************* 27 2018-07-01 11:37 41 ********************** 28 2018-07-01 11:38 41 ********************** 29 2018-07-01 11:39 41 ********************** 30 2018-07-01 11:40 42 *********************** 31 2018-07-01 11:41 43 ************************ ... ..( 2 skipped). .. ************************ 34 2018-07-01 11:44 43 ************************ 35 2018-07-01 11:45 44 ************************* ... ..( 14 skipped). .. ************************* 50 2018-07-01 12:00 44 ************************* 51 2018-07-01 12:01 45 ************************** ... ..( 45 skipped). .. ************************** 97 2018-07-01 12:47 45 ************************** 98 2018-07-01 12:48 46 *************************** ... ..( 13 skipped). .. *************************** 112 2018-07-01 13:02 46 *************************** 113 2018-07-01 13:03 45 ************************** 114 2018-07-01 13:04 45 ************************** 115 2018-07-01 13:05 ? - 116 2018-07-01 13:06 28 ********* 117 2018-07-01 13:07 29 ********** 118 2018-07-01 13:08 31 ************ 119 2018-07-01 13:09 31 ************ 120 2018-07-01 13:10 32 ************* 121 2018-07-01 13:11 33 ************** 122 2018-07-01 13:12 34 *************** 123 2018-07-01 13:13 35 **************** 124 2018-07-01 13:14 37 ****************** 125 2018-07-01 13:15 37 ****************** 126 2018-07-01 13:16 38 ******************* 127 2018-07-01 13:17 38 ******************* 0 2018-07-01 13:18 40 ********************* 1 2018-07-01 13:19 39 ******************** 2 2018-07-01 13:20 40 ********************* 3 2018-07-01 13:21 41 ********************** 4 2018-07-01 13:22 41 ********************** 5 2018-07-01 13:23 41 ********************** 6 2018-07-01 13:24 42 *********************** 7 2018-07-01 13:25 42 *********************** 8 2018-07-01 13:26 42 *********************** 9 2018-07-01 13:27 43 ************************ 10 2018-07-01 13:28 44 ************************* ... ..( 2 skipped). .. ************************* 13 2018-07-01 13:31 44 ************************* 14 2018-07-01 13:32 45 ************************** 15 2018-07-01 13:33 46 *************************** 16 2018-07-01 13:34 45 ************************** 17 2018-07-01 13:35 46 *************************** 18 2018-07-01 13:36 47 **************************** 19 2018-07-01 13:37 47 **************************** 20 2018-07-01 13:38 47 **************************** 21 2018-07-01 13:39 48 ***************************** 22 2018-07-01 13:40 48 ***************************** 23 2018-07-01 13:41 48 ***************************** 24 2018-07-01 13:42 47 **************************** SCT Error Recovery Control: Read: Disabled Write: Disabled Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x0001 2 0 Command failed due to ICRC error 0x0002 2 0 R_ERR response for data FIS 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0005 2 0 R_ERR response for non-data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS 0x000a 2 6 Device-to-host register FISes sent due to a COMRESET 0x8000 4 2258 Vendor specific